Does wiring seem correct? Ok-Statistician8735 3 months ago by Ok-Statistician8735 I can’t see the blue and yellow but if there plugged in the z axis than yes it is wired corect Reply You can plug it in the 5 pin but you will need to recompile the firmware to make it know that you are using the 5 pin instead of the z axis end stop. Reply not the same board but roughly the same i imagine Reply I’ve managed to get a blue led to turn on. But to get the entire thing to actually work has me stumped. I’ve triple checked my firmware and everything is correct. I just can’t seem to see where the issue is coming from Reply Leave a Reply Cancel replyYour email address will not be published. Required fields are marked *Comment Name * Email * Website Author: admin
You can plug it in the 5 pin but you will need to recompile the firmware to make it know that you are using the 5 pin instead of the z axis end stop. Reply
I’ve managed to get a blue led to turn on. But to get the entire thing to actually work has me stumped. I’ve triple checked my firmware and everything is correct. I just can’t seem to see where the issue is coming from Reply
I can’t see the blue and yellow but if there plugged in the z axis than yes it is wired corect
You can plug it in the 5 pin but you will need to recompile the firmware to make it know that you are using the 5 pin instead of the z axis end stop.
not the same board but roughly the same i imagine
I’ve managed to get a blue led to turn on. But to get the entire thing to actually work has me stumped. I’ve triple checked my firmware and everything is correct. I just can’t seem to see where the issue is coming from